World Library  
Flag as Inappropriate
Email this Article


Article Id: WHEBN0010485640
Reproduction Date:

Title: FCoE  
Author: World Heritage Encyclopedia
Language: English
Subject: Quality of service, ISCSI, Fibre Channel, ATA over Ethernet, Emulex, Internet Fibre Channel Protocol, IBM Storage, ATTO Technology, VMQ
Publisher: World Heritage Encyclopedia


"FCOE" redirects here. For the Congolese airport with that ICAO code, see Ewo Airport.

Fibre Channel over Ethernet (FCoE) is a computer network technology that encapsulates Fibre Channel frames over Ethernet networks. This allows Fibre Channel to use 10 Gigabit Ethernet networks (or higher speeds) while preserving the Fibre Channel protocol. The specification was part of the International Committee for Information Technology Standards T11 FC-BB-5 standard published in 2009.[1]


FCoE maps Fibre Channel directly over Ethernet while being independent of the Ethernet forwarding scheme. The FCoE protocol specification replaces the FC0 and FC1 layers of the Fibre Channel stack with Ethernet. By retaining the native Fibre Channel constructs, FCoE was meant to integrate with existing Fibre Channel networks and management software.

Data centers used Ethernet for TCP/IP networks and Fibre Channel for storage area networks (SANs). With FCoE, Fibre Channel becomes another network protocol running on Ethernet, alongside traditional Internet Protocol (IP) traffic. FCoE operates directly above Ethernet in the network protocol stack, in contrast to iSCSI which runs on top of TCP and IP. As a consequence, FCoE is not routable at the IP layer, and will not work across routed IP networks.

Since classical Ethernet had no priority-based flow control, unlike Fibre Channel, FCoE required enhancements to the Ethernet standard to support a priority-based flow control mechanism (to reduce frame loss from congestion). The IEEE standards body added priorities in the data center bridging Task Group.

Fibre Channel required three primary extensions to deliver the capabilities of Fibre Channel over Ethernet networks:

  • Encapsulation of native Fibre Channel frames into Ethernet Frames.
  • Extensions to the Ethernet protocol itself to enable an Ethernet fabric in which frames are not routinely lost during periods of congestion.
  • Mapping between Fibre Channel N_port IDs (aka FCIDs) and Ethernet MAC addresses.

Computers can connect to FCoE with converged network adapters (CNAs), which contain both Fibre Channel host bus adapter (HBA) and Ethernet Network Interface Card (NIC) functionality on the same adapter card. CNAs have one or more physical Ethernet ports. FCoE encapsulation can be done in software with a conventional Ethernet network interface card, however FCoE CNAs offload (from the CPU) the low level frame processing and SCSI protocol functions traditionally performed by Fibre Channel host bus adapters.


The main application of FCoE is in data center storage area networks (SANs). FCoE has particular application in data centers due to the cabling reduction it makes possible, as well as in server virtualization applications, which often require many physical I/O connections per server.

With FCoE, network (IP) and storage (SAN) data traffic can be consolidated using a single network. This consolidation can:

  • reduce the number of network interface cards required to connect to disparate storage and IP networks
  • reduce the number of cables and switches
  • reduce power and cooling costs

Frame Format

FCoE is encapsulated over Ethernet with the use of a dedicated Ethertype, 0x8906. A single 4-bit field (version) satisfies the IEEE sub-type requirements. The SOF (start of frame) and EOF (end of frame) are encoded as specified in RFC 3643. Reserved bits are present to guarantee that the FCoE frame meets the minimum length requirement of Ethernet. Inside the encapsulated Fibre Channel frame, the frame header is retained so as to allow connecting to a storage network by passing on the Fibre Channel frame directly after de-encapsulation.

The FIP (FCoE Initialization Protocol) is an integral part of FCoE. Its main goal is to discover and initialize FCoE capable entities connected to an Ethernet cloud. FIP uses a dedicated Ethertype of 0x8914.


Azul Technology developed early version and applied for a patent in October 2003. [2]

The FCoE standardization activity started in April 2007. The FCoE technology was defined as part of the International Committee for Information Technology Standards (INCITS) T11 FC-BB-5 standard that was forwarded to ANSI for publication in June 2009.[1] The FC-BB-5 standard was published in May 2010 as ANSI/INCITS 462-2010.[3] Some additional work was done in the INCITS.[4]

An early implementor was Nuova Systems, a subsidiary of Cisco Systems, which announced a switch in April 2008.[5][6] Brocade Communications Systems also announced support in 2008.[7] After the late-2000s financial crisis, however, any new technology had a hard time getting established.[8][9] By September 2011 some competitors to Cisco were calling the technology "dead".[10]

The datacenter switches from Force10 and Dell PowerConnect support FCoE and in June 2013 Dell Networking, which is the new brand-name for all networking portfolio of Dell, will introduce the S5000 series which can be a fully native FCoE switch with the option to include a native fibre channel module, allowing you to connect the S5000 directly to an FC SAN environment[11]

See also


External links

This article was sourced from Creative Commons Attribution-ShareAlike License; additional terms may apply. World Heritage Encyclopedia content is assembled from numerous content providers, Open Access Publishing, and in compliance with The Fair Access to Science and Technology Research Act (FASTR), Wikimedia Foundation, Inc., Public Library of Science, The Encyclopedia of Life, Open Book Publishers (OBP), PubMed, U.S. National Library of Medicine, National Center for Biotechnology Information, U.S. National Library of Medicine, National Institutes of Health (NIH), U.S. Department of Health & Human Services, and, which sources content from all federal, state, local, tribal, and territorial government publication portals (.gov, .mil, .edu). Funding for and content contributors is made possible from the U.S. Congress, E-Government Act of 2002.
Crowd sourced content that is contributed to World Heritage Encyclopedia is peer reviewed and edited by our editorial staff to ensure quality scholarly research articles.
By using this site, you agree to the Terms of Use and Privacy Policy. World Heritage Encyclopedia™ is a registered trademark of the World Public Library Association, a non-profit organization.

Copyright © World Library Foundation. All rights reserved. eBooks from World eBook Library are sponsored by the World Library Foundation,
a 501c(4) Member's Support Non-Profit Organization, and is NOT affiliated with any governmental agency or department.