Honeycomb
A natural comb of
Apis dorsata. The lower part of the comb has a number of unoccupied cells.
A honeycomb is a mass of hexagonal wax cells built by honey bees in their nests to contain their larvae and stores of honey and pollen.
Beekeepers may remove the entire honeycomb to harvest honey. Honey bees consume about 8.4 lbs (4 kg) of honey to secrete 1 lb (500 g) of wax,^{[1]} so it makes economic sense to return the wax to the hive after harvesting the honey, commonly called "pulling honey" or "robbing the bees" by beekeepers. The structure of the comb may be left basically intact when honey is extracted from it by uncapping and spinning in a centrifugal machine—the honey extractor. If the honeycomb is too worn out, the wax can be reused in a number of ways, including making sheets of comb foundation with hexagonal pattern. Such foundation sheets allow the bees to build the comb with less effort, and the hexagonal pattern of workersized cell bases discourages the bees from building the larger drone cells.
"Artificial honeycomb" plate where bees have already completed some cells
Fresh, new comb is sometimes sold and used intact as comb honey, especially if the honey is being spread on bread rather than used in cooking or as a sweetener.
Broodcomb becomes dark over time, because of the cocoons embedded in the cells and the tracking of many feet, called travel stain by beekeepers when seen on frames of comb honey. Honeycomb in the "honey supers" that are not allowed to be used for brood (e.g. by the placement of a queen excluder) stays lightcoloured.
Numerous wasps, especially Polistinae and Vespinae, construct hexagonal prismpacked combs made of paper instead of wax; in some species (such as Brachygastra mellifica), honey is stored in the nest, thus technically forming a paper honeycomb. However, the term "honeycomb" is not often used for such structures.
Honeycomb geometry
Natural honeycombs on a building
Honeycomb with eggs and
larvae
The bees begin to build the comb from the top of each section. When a cell is filled with honey, the bees seal it with wax.
Closeup of an abandoned
Apis florea nest,
Thailand – the hexagonal grid of wax cells on either side of the nest are slightly offset from each other. This increases the strength of the comb and reduces the amount of wax required to produce a robust structure.
The axes of honeycomb cells are always quasihorizontal, and the nonangled rows of honeycomb cells are always horizontally (not vertically) aligned. Thus, each cell has two vertical walls, with "floors" and "ceilings" composed of two angled walls^{(disparity with image "HoneycombProcess")}. The cells slope slightly upwards, between 9 and 14°, towards the open ends.
Two possible explanations exist as to why honeycomb is composed of hexagons, rather than any other shape. First, the hexagonal tiling creates a partition with equalsized cells, while minimizing the total perimeter of the cells. Known in geometry as the honeycomb conjecture, this was given by Jan Brożek and proved much later by Thomas Hales. Thus, a hexagonal structure uses the least material to create a lattice of cells within a given volume. A second reason, given by D'Arcy Wentworth Thompson, is that the shape simply results from the process of individual bees putting cells together: somewhat analogous to the boundary shapes created in a field of soap bubbles. In support of this, he notes that queen cells, which are constructed singly, are irregular and lumpy with no apparent attempt at efficiency.^{[2]}
The closed ends of the honeycomb cells are also an example of geometric efficiency, albeit threedimensional and littlenoticed. The ends are trihedral (i.e., composed of three planes) sections of rhombic dodecahedra, with the dihedral angles of all adjacent surfaces measuring 120°, the angle that minimizes surface area for a given volume. (The angle formed by the edges at the pyramidal apex, known as the tetrahedral angle, is approximately 109° 28' 16" (= arccos(−1/3)).)
The threedimensional geometry of a honeycomb cell
The shape of the cells is such that two opposing honeycomb layers nest into each other, with each facet of the closed ends being shared by opposing cells.
Opposing layers of honeycomb cells fit together
Individual cells do not show this geometric perfection: in a regular comb, deviations of a few percent from the "perfect" hexagonal shape occur. In transition zones between the larger cells of drone comb and the smaller cells of worker comb, or when the bees encounter obstacles, the shapes are often distorted. Cells are also angled up about 13° from horizontal to prevent honey from dripping out.^{[3]}
Honeycomb section containing transition from worker to drone (larger) cells – here bees make irregular and fivecornered cells (marked with red dots).
Western honeybees and honeycomb
In 1965, László Fejes Tóth discovered the trihedral pyramidal shape (which is composed of three rhombi) used by the honeybee is not the theoretically optimal threedimensional geometry. A cell end composed of two hexagons and two smaller rhombuses would actually be .035% (or about one part per 2850) more efficient. This difference is too minute to measure on an actual honeycomb, and irrelevant to the hive economy in terms of efficient use of wax, considering wild comb varies considerably from any mathematical notion of "ideal" geometry.^{[4]}^{[5]}
See also
References

^ Graham, Joe. The Hive and the Honey Bee. Hamilton/IL: Dadant & Sons; 1992; ISBN.

^ Thompson, D'Arcy Wentworth (1942). On Growth and Form. Dover Publications. ISBN.

^ Frisch, Karl von (1974). Animal Architecture. New York: Harcourt Brace Jovanovich.

^ Bessiere, Gustavo (1987). Il Calcolo Differenziale e Integrale—Reso Facile ed Attraente.IL (in Italian) (VII ed.). Milan: Hoepli.

^ Gianni A. Sarcone. "The solved angular puzzle of the honeycombs' cells". 2004.
External links
This article was sourced from Creative Commons AttributionShareAlike License; additional terms may apply. World Heritage Encyclopedia content is assembled from numerous content providers, Open Access Publishing, and in compliance with The Fair Access to Science and Technology Research Act (FASTR), Wikimedia Foundation, Inc., Public Library of Science, The Encyclopedia of Life, Open Book Publishers (OBP), PubMed, U.S. National Library of Medicine, National Center for Biotechnology Information, U.S. National Library of Medicine, National Institutes of Health (NIH), U.S. Department of Health & Human Services, and USA.gov, which sources content from all federal, state, local, tribal, and territorial government publication portals (.gov, .mil, .edu). Funding for USA.gov and content contributors is made possible from the U.S. Congress, EGovernment Act of 2002.
Crowd sourced content that is contributed to World Heritage Encyclopedia is peer reviewed and edited by our editorial staff to ensure quality scholarly research articles.
By using this site, you agree to the Terms of Use and Privacy Policy. World Heritage Encyclopedia™ is a registered trademark of the World Public Library Association, a nonprofit organization.